OutBack Power FX2548T Sine Wave Inverter
[FX2548T]

OutBack Power FX2548T Sine Wave Inverter

FX2548T Sine Wave Inverter 2500W, 48VDC 120VAC, 60Hz sealed, w/turbo

OutBack
FX 2548T Inverter-Charger

A New Standard of Performance
• True Sinewave Output
• Low THD
• Over Three Times Surge Capacity
• 60 Amp AC Transfer Switch
• Low Idle Power Consumption
• Super Efficient
• Five Stage Smart Charger
• Series Stackable
• Parallel Stackable
• Three Phase Stackable

The OutBack FX series is a modular "building block” sine wave inverter/charger that can be used for both small and large power systems. Each OutBack FX inverter/charger is a complete power conversion system - DC to AC inverter, battery charger and AC transfer switch. Additional FX inverter/chargers can be connected at any time in either parallel (120 VAC), series (120/240 VAC), or three-phase (120Y208 VAC) configurations. This allows a system to be tailored to meet the specific power conversion requirements of the application, both at the time of the installation and in the future.

The OutBack FX series is also available in export versions with 230 VAC, 50 Hz output that can be connected in parallel (230 VAC) or in three phase (230Y400 VAC) configurations. The OutBack FX is designed to survive harsh environments anywhere in the world. Our unique sealed, gasketed die-cast aluminum chassis protects and keeps the power conversion components cool - without requiring outside air to be blown through the sensitive electronics. This reduces the major causes of inverter failure - corrosion, dust, insect and animal damage. The FX can be used in high ambient applications up to 60oC with reduced output ratings.

The OutBack FX series inverter/charger system is designed for both residential and commercial stand-alone or back-up power applications with battery energy storage. It is designed to operate as a coordinated system with the other OutBack products i.e. the PS2DC, PSDC, PS2AC, PSAC and PSR enclosures as well as the MX60 MPPT charge controllers and MATE system controller and display.

Sealed Construction Features:
• Powdercoated all aluminum die-cast chassis
• Internal electronic components are cooled by heat transfer
• Gaskets on all openings to provide water-resistance
• Sealed design protects internal electronics from salt, dirt or contaminated air, bugs, critters, mold etc.
• Conformal coated circuit boards to resist corrosion
• Designed to allow easy field servicing and repair

Ideal Applications:
• Hot and humid climates where a protected area is not available for installation of the inverter/charger system
• Salt air environments such as Hawaii where you can’t get away from the salt air and where there is little difference between indoors and outdoors
• Dirty environments where dust or drifting organic matter such as cottonwood could clog an air opening in an unattended system
• Boats and RV’s where water might splash on the inverter
• Greater control of unwanted radio frequency interference