Morningstar SS10L-24 SunSaver 10 Charge Controller with LVD

We recently made changes to our inventory of products and decided to no longer carry this item.

If you are still interested in purchasing the Morningstar SS10L-24 please use the following Amazon product link.

Morningstar SS10L-24 SunSaver 10 Charge Controller with LVD

Doing so will help us continue to employ our wonderful staff that works hard to support every customer everyday.

With warmest regards,

Infinigi Staff
Morningstar SS10L-24 Summary
Product Type
Charge Controller
Battery Voltage
24 Volts
Charging Type
Output Current
10 Amps
PV Open Circuit Voltage
60 Voc
PV Input @ 24V
240 Watts

Morningstar SS10L-24 SunSaver 10 Charge Controller with LVD

SS10L-24 SunSaver 10 Charge Controller , w/LVD, 24V, 10 Amp

Morningstar is pleased to introduce our third generation SunSaver. Since its first market introduction in 1996, over 1 million SunSaver controllers have been installed in over 73 countries for numerous solar power systems including oil/gas, telecom and instrumentation, marine and boating, and remote homes. We have retained much of our legacy design including the same ratings, footprint and simple user interface, and have added several new and advanced high value features:

  • Full Electronic Protections
  • 3 LED’s for battery state of charge
  • Maximum charge limiting for sensitive loads
  • 4 stage battery charging
  • Dead battery recovery
  • Cover to protect wire terminals
  • Self-diagnostics to detect critical faults
  • Multi-color status LED
  • Telecom mode for sensitive loads
  • Extremely High Reliability
    • Failure rate of less than 1 per 1,000 shipped (<0.1%)
    • 100% solid state. Power MOSFET design
    • Manufactured in an ISO 9000 factory
    • 100% pre-shipment functional testing
  • Longer Battery Life
    • Advanced PWM charging
    • Series design (not shunt) for cool operation
    • 4-stage charging: bulk, absorption, float, equalize
    • Optimized sealed or flooded battery set points
    • Temperature compensated charging
    • Low voltage load disconnect on several versions
  • Designed for Harsh Environments
    • Temperature rating of –40°C to +60°C
    • Epoxy encapsulation for protection against humidity and dust ingress
    • Corrosion protection: marine rated terminals and anodized aluminum case
    • Certified for use in hazardous location
  • Easy to Install and Use
    • Factory pre-sets result in no required install settings
    • Electronic protections prevent damage from wiring mistakes
    • Fully automatic operation and fault recovery
    • LED’s display extensive information about status, faults and battery condition

Also Known As:
SS10L 24

Sunsaver (Gen3)Specification
Peak Efficiency97 .50%
System Voltage12 or 24 volts
Min. Battery Voltage1volt
Regulation voltage12 volt24 volt
Sealed battery14.1 V28.2 V
Flooded battery14.4 V28.8 V
Load disconnect11.5 V23.0 V
LVD reconnect12.6 V25.2 V
Max. Solar Voltage
12V battery30 volts
24V battery60 volts
Load in-rush capability
SunSaver-645 amps
SunSaver-1065 amps
SunSaver-20140 amps
Self-consumption< 8 mA
Voltage accuracy12V: +/– 25 mV (typical)
24V: +/– 48 mV (typical)
Transient surge protection1500W per connection
Wire Size5 mm2 / #10 AWG
Weight (unpacked)0.23kg / 8 oz.
Dimensions15.2 x 5.5 x 3.4 cm
6.0 x 2.2 x 1.3 inch
Ambient Temperature–40°C to +60°C
Storage Temperature–55°C to +80°C
Humidity100% non-condensing
TropicalizationEpoxy encapsulation
Marine rated terminals
Anodized aluminum case
Electronic Protections
Solar:Overload, short-circuit, high voltage
Load:Overload, short-circuit, high voltage
Battery:High voltage
All:Reverse polarity, high temperature, lightning
and transient surges
Battery Charging
Charging method4 stage series PWM
Charging stagesBulk, absorption, float, equalize
Temperature compensation
Coefficient 12V: –30mV/°C
24V: –60mV/°C
Range–30°C to +60°C
Set PointsAbsorption, float, equalize
LED Indications
Status LED (1)Charging or not charging
Solar error conditions
Battery LED’s (3)Battery level
Charging stage
CertificationsETL Listed to UL 1741 and CSA C22.2 No. 107.1-01
Hazardous LocationsClass 1, Division 2,
Groups A,B,C,D
CSA C22.2#213
EMC DirectivesImmunity, emissions, safety
FCCClass B Part 15
Note: Specifications and pricing of the Morningstar SS10L-24 SunSaver 10 Charge Controller with LVD subject to change without notice. Illustrations and descriptions of the Morningstar SS10L-24 do not claim to be complete or exhaustive.

Customers Who Bought the Morningstar SS10L-24 SunSaver 10 Charge Controller with LVD Also Purchased:

PaypalVisaMastercardAmerican ExpressDiscover
Manufacturer Info
Share Product
Share via E-Mail 
 Share on Facebook Share on Twitter