Magnum Energy ME-BMK-NS Battery Monitoring Kit - NO DC SHUNT
ME-BMK-NS Battery Monitoring Kit, NO DC SHUNT - Battery State of Charge Meter
The ME-BMK-NS (Battery Monitor Kit)* from Magnum Energy gives you a "fuel gauge" type of meter for your battery bank. It monitors the battery bank and reports the percentage state of charge, real time amps, voltage, amp-hours in/out, and the minimum/maximum DC volts.
Monitoring your battery bank is easy with the Battery Monitor Kit (ME-BMK)* from Magnum Energy. Acting as a "fuel gauge" for your batteries, the ME-BMK monitors their state of charge (SOC) and then provides this information in an easy-to-understand display via the ME-RC remote. With accurate SOC readings, you can avoid unneccessary battery recharging, saving on fuel and long-term maintenance costs. If you already have a Magnum Inverter/Charger and Magnum Remote*, the ME-BMK is an easy retrofit. Simply install the kit according to the installation manual and begin monitoring your battery bank via the "Meter" button on your ME-RC.
* The ME-BMK-NS requires a Magnum inverter with a "Network" port and a ME-RC (revision 2.0 or higher) or ME-ARC remote control.
Available readings from the ME-BMK
The Magnum Energy ME-BMK-NS Battery Monitoring Kit - NO DC SHUNT Includes:
Also Known As:
ME BMK NS
|DC volts||7 to 70 (±0.5%) auto voltage detection|
|DC amps||±0.1 to 999 (±1.0%)|
|Battery SOC %||0 to 100% (1% increments)|
|Power draw||< .6 watts|
|Amp hours in/out||±32,768 amp hours (1 AH increments)|
|rAH out (resettable amp hours removed)||0 to 65,353 amp hours, resettable (0.1 AH increments)|
|tAH out (total amp hours removed)||0 to 65,535,000 amp hours (0.1 k or 100 AH increments)|
|Minimum/maximim DC||7 to 70 VDC, resettable|
|Shipping weight||2 lb (.9 kg)|
|Kit includes||Manual, sense module, DC shunt, twisted pair wire, and communication cable|
|Sense wire||Twisted pair —blue & orange, 5' length, 18 AWG wire|
|Communication cable||2-conductor, 10' twisted pair, telephone standard|
|Remote requirements||Use with an ME-RC with firmware revision of 2.0 or higher|