Xantrex GTI
Xantrex GTI Grid Tie Interface for SW Series Inverters

GTI Grid tie interface for SW Series inverters

Xantrex
GTI Grid Tie Interface for SW Series Inverters

Grid Tie Interface (GTI)

The GTI is an integrated assembly that allows you to connect the Xantrex SW Series II inverter/charger to the utility grid.

Applications
Use the Grid Tie Interface (GTI) to run the SW Inverter/Charger in utility interactive Sell Mode.
For use with new 4.0 kVA and 5.5 kVA SW Inverter/Chargers containing Rev 4.2 or higher firmware.

Features
Significantly improves performance and power quality in Sell Mode.
Meets IEEE 519 for power quality (THD).
Compliant with IEEE 929 and UL 1741 anti-islanding standards.
Increases overall inverter sell back efficiency, using Xantrex' proprietary Phase Control feature.
Easy Installation.

Specifications

	Electrical Specifications
	Utility Interactive Protection		Over/under AC voltage and frequency detection plus active islanding detection
	AC Voltage (Nominal)		120 VAC
	AC Voltage (Allowed):
	Utility Interactive Mode		106 - 132 VAC
	Bypass Mode (Adjustable)		80 - 149 VAC inverter controlled
	Frequency (Allowed):
	Utility Interactive Mode		59.3 - 60.5 Hz
	Bypass Mode (Adjustable)		53.0 - 67.0 Hz inverter controlled
	AC Current (Allowed at 25 C):
	Utility Interactive Mode		40 amps continuous
	Bypass Mode (Adjustable)		60 amps continuous
	Total Output Harmonic Distortion
	Rated		< 5% at full power
	Typical		2.5% at full power
	Power Factor (Allowed)		> 94%
	General Specifications
	Enclosure Type		Indoor, ventilated, steel chassis with white, powder coat finish
	Unit Weight		26 lb (11.8 kg)
	Dimensions (H x W x D)		6.3 x 21.0 x 7.0" (16 x 53.3 x 17.8 cm)
	Mounting		Wall mount in a horizontal position only with a mounting bracket
	AC Input/Output Terminals		Sized for #2 - 14# AWG wire
	Conduit Sizes		Dual 3/4" - 1" and 1/2" - 3/4" knockouts available
	Warranty		Two years
	Part Number		GTI
	Regulatory Approvals
	CSA Listed to UL1741 - 1st Edition
	UL Listed to UL1741 - 1st Edition