OutBack Power Systems Rack PSR
The OutBack Power Systems PSR provides a safe and attractive way to install batteries in renewable energy systems. It can be used to also enclose a power inverter, charge controller and overcurrent protection – a complete renewable energy power system can be installed in a single cabinet (with sealed batteries only). The PSR Power System Rack includes removable top & side panels, two shelves and conduit/breaker knockout plates. The front bracket will hold one DCGFP/2, two PV array disconnect breakers and one large inverter/battery breaker.
The PSR is built with corrosion resistant steel and is shipped knocked down for easy transportation and storage. The cabinet can be assembled with additional shelves for more batteries or other components.
A front mounted bracket is provided to allow the installation of a inverter/battery disconnect breaker, two PV array disconnects and a two pole PV ground fault protection system. An optional hinged breaker cover can be field installed to allow locking of the breakers or to prevent tampering. The PSR should include the circuit breakers only when used with sealed batteries.
An optional battery spill containment tray can be used on each shelf to prevent damage from battery spill or mist during charging. It can also be used as a vent hood when mounted upside down in the top of the enclosure with vent piping to prevent accumulation of hydrogen gas inside of the enclosure.
An optional seismic zone 4 kit is also available to allow the installation to comply with local and national building code standards. The kit includes two mounting feet and twelve battery restraint straps.
An optional PSR mounting plate is also available to allow the installation of various power electronic components inside of the enclosure with sealed batteries.
An optional heavy duty top is also available to allow the mounting of inverters directly on top of the PSR for indoor installations.
Also available is a outdoor rainproof version (PSR-3R) and a frame only version (PSR-FO) without the side and top panels for use as a battery rack inside restricted access equipment rooms.
PSR Power System Rack – standard indoor version with removable panels and top – includes two shelves
PSR-3R Power System Rack – Type 3R / Outdoor Version – Same as the PSR indoor version except the top and side panels are insulated / gasketed and includes a rainshield type top cover and a breaker cover kit
PSR-FO Power System Rack – Frame Only Version – same as the PSR except without the side and top panels and the breaker/conduit brackets – includes three shelves standard Available Options
PSR-HDT Heavy Duty Top – allows mounting of an SW series inverter/charger with a conduit box on top of a PSR
PSR-SK Shelf Kit – adds another shelf to the PSR for more batteries or an inverter/charger with sealed batteries
PSR-SZ4 Seismic Zone 4 Kit – includes two mounting feet and battery restraint straps for up to 12 batteries
PSR-BCK Breaker Cover Kit – transparent flip-up cover with mounting screws and padlock hasp
PSR-SCT Spill Containment Tray – Holds four Group 31, T105, or L16 batteries – Fits on one PSR shelf
PSR-MP Mounting Plate - attaches to the back of a PSR to allow mounting of electrical components