Midnite Solar MNE125STMM-L
Midnite Solar MNE125STMM-L Gray Steel Magnum E-Panel for MM Series

Midnite Solar MNE125STMM-L Gray Steel Magnum E-Panel for MM Series

Midnite Solar MNE125STMM-L Gray Steel Magnum E-Panel for MM Series

Magnum Energy makes a very interesting line of inverters, both modified and pure sine wave. The RE industry is embracing both types of inverters so MidNite builds E-Panels to accommodate all of the RD and MS series. Internal AC wires are routed to match the Magnum inverter rather than OutBack. The accessory components like the DC cover, top shield, remote bracket and such are specific to the Magnum E-Panels. Like the Stretched OB E-Panel, the Magnum has a PV input plus and DC plus busbar as well as the regular AC input and output busbars. This chassis is 14.4 inches wide, so has ample room for all your wiring needs. The chassis is only 3.5” deep so wiring access is the best in the industry. All of the present 12 and 24 volt Magnum inverters have a 120VAC inverter/charger input/output as well as a 120VAC input/output that does not go through the electronics. It is strictly a pass through for the other leg of a 240VAC input. The pass through leg can be useful when attempting to utilize both legs of a 240VAC generator. One leg is used for charging and the other is used to pass through to your 240VAC deep well pump. Normal installations jumper AC 1&2 on the inverter for 50 amp service at 120VAC.

Features of the Midnite Solar MNE125STMM-L Gray Steel Magnum E-Panel for MM Series:

• Left door for MM series
• Steel left hand units come with pre-wired AC bypass and AC input
• 125 Amp inverter battery breaker
• AC input and output busbars, PV+ input busbar, 80 amp Battery + busbar, battery- busbar, chassis ground busbar
• 500 amp / 50mv shunt included for battery monitoring systems
• Charge control bracket, 2 AWG inverter DC cables
• 15 amp AC input disconnect for generator or utility included, pre-wired
• 15 amp AC bypass switch for bypassing inverter circuit, pre-wired
• Mounting hole in door for MMRC control panel, din rails for 6 additional AC or DC breakers, knock outs for 3 panel mount breakers, GFCI knockout, mounting brackets.
• Battery cable cover to enclose cables external to the chassis***
• Inverter and charge controller mounting hardware
• Rectangular cut outs for mounting a North American GFCI style AC outlet
• Cut outs for mounting up to six additional 13mm wide din rail mount breakers for additional circuits such as PV, wind, hydro or AC distribution
• Plastic snap in conduit and fittings from chassis to inverter for AC, BTS and control circuits (OB versions)
• ETL listed to UL and CSA standards
*** LT versions do not have a cable cover, MM series uses the inverter battery terminal caps

Also Known As:
MNE125STMM.L
MNE125STMM L
MNE125STMM_L
MNE125STMML